I do believe it will work if you do not have a power steering pump FFHill. (sigh)
I have seen that web page too.
The bracket Reddot made for the M939A0-A1 is designed to use the power steering pumps
belts (extended) . You just bolt on this bracket and change power steering
belts. There is another part needed and part of the bracket called
a TIGHTENER, part 39. In my picture.
Look, I found all the info regarding the OE M934 parts yesterday guys ...
I have had extended discussions w/ two men at RedDot.
RedDot has plans and part numbers for every last part for the M934's
system. I have seen it, but they REFUSE to sell us the bracket. They can't!
PERIOD. They are bound by the terms and conditions of the DOD.
Our only hope is each of us make our own bracket
OR, if someone
who owns an M934 w/ this system, if they would pull the bracket
and send it to someone
like me who will reverse engineer it and
put it to paper via CAD so it can be reproduced. That would be the
easiest way to do it by far. If they would trust just me to send it back,
(My ebay feedback is over 1000 and 100% and all my info is public) If they
mailed it to me I CAN draw it in CAD so it were reproducable.
Heck they could make money doing this too!
BUT, the bracket is only good for THEIR compressor. If whoever owns
this M934 could give us the OE part number from the manufacturer
we can see if that compressor that fits that bracket is available
to us, again, Reddot will not sell it to us.
I have all Reddots part numbers. It will do no good to post them.
Alls it will do is cause 1000's of guys to call RD over the years reading this thread
and cause them grief w/ guys looking for it. Not gonna do it.
I sent a link to this particular thread to RD as well, perhaps they will see the
light and develop ANOTHER bracket w/ a different part number that
they can sell to the public.
I even called Cummins in El Cajon. They called back this AM empty.
SIGH
Here is EXACTLY what we need. Yea, I could fab this up but it will
take a LOT of time, plus I need a compressor that I can buy and
buy AGAIN if it fails to design with. If I had this bracket...I could draw it
sitting here at my desk. I am bummed. Another part made of unobtainium.
View attachment 416996
WAIT! STOP THE PRESSES!
I just found the freakin' compressor on EBAY and I BOUGHT IT!
muhahahahahahahahahahahahahahahaha
Oh man...I SO NEED THAT BRACKET SO I CAN DRAW IT IN CAD!
THE NSN NUMBER FOR THE COMPRESSOR IS
4130-01-521-7816