what does this fit?

[vinny-socom1]

Hello everyone,

I have ran across some rims that I can not figure out what they fit. I know they don't fit 800 series 5ton trucks, 10 lug but wrong spacing ? I was able to retrieve a NSN#2530014799216 Oshkosh Truck Corp 20x10 Titan wheels. Thanks Vinny

 

[Jones]

There's a drwg in the tech library of a Hayes wheel designed for the HEMTTs. (Titled wrong; 1100X20 should be 1000X20) Take a look at it and see if thet's the lug spacing on your wheels. If not HEMTT, maybe FMTV or LMTV.

 

[dma251]

That's a hemtt A2 bolt-together wheel. I sure wish I had just ONE more....... I have 8 now, but I am still searching for a ninth for my spare.....

It's definitely a hemtt wheel, though. I'm tripping over 'em in my garage right now.

 

[acetomatoco]

Oshkosh equals Hemtt

 

[emmado22]

Oshkosh also = PLS, Super HET, and MTVR They are the titans of the American military heavy truck industry.

 

[vinny-socom1]

my friend has 24 for sale!!!! He also has about 16 5 ton trucks that they won't fit... Vinny

 

[houdel]

my friend has 24 for sale!!!! He also has about 16 5 ton trucks that they won't fit... Vinny

Will they fit a 10 ton truck? Pilot hole 11" or so, bolt pattern 10 lug nuts on about 12.75" diameter IIRC? If so, I could use about 9 myself. If those numbers are close, I can go back to the manuals and come up with the actual numbers. That would make them PLS rims, not Hemtt.

 

[vinny-socom1]

if you tell what to measure the next time at over to his place I'll check them?? I'm not sure if you can reverse look up with the NSN# ? Vinny

 

[Poccur]

A search on that NSN gives a number of vendors. Oshkosh is one but also Accuride. It lists Accuride part number 29729.
Accuride list is as an active part number, lifted the attached from their catalog.

Have not linked it to a vehicle but it does give more info on the item.

Cheers

Poccur

 

[screaminseeman]

I have a couple sets of these wheels, one of witch I will be running on my bobbed duece. Does anyone have a good inexspensive source for o-rings for these wheels?

 

[M1075]

Those wheels might be the 2 piece rims from the M1076. I could use them. Can you PM me with your friend's contact info?

 

[M1075]

I have a couple sets of these wheels, one of witch I will be running on my bobbed duece. Does anyone have a good inexspensive source for o-rings for these wheels?

Which o-rings are you after? The rims in this thread are not going to fit a deuce without new centers cut. Do you have these exact rims or something else?

 

[screaminseeman]

I need the o-rings that seal the two halves. I own www.screaminseeman.com and the new centers to convert the wheels to a 5-ton pattern are already done

 

[M1075]

I need the o-rings that seal the two halves. I own www.screaminseeman.com and the new centers to convert the wheels to a 5-ton pattern are already done

Why are you converting to a 5-ton pattern when you have a bobbed deuce? I think you might run into a few problems there.

 

[screaminseeman]

Because I am putting front and rear steer 5-ton axles under my duece.

 

[M1075]

Ahhhh, that makes sense now.