Search results

Does the gen2 light come on at all? If not swap out the gen1 and gen2 bulbs to check the bulb. Also the contacts get dirty and or corroded on the bulb socket at the printed curcit board clean the board and socket then turn the socket several time to get a good contact. Hope this helps!

A little to far for me to pick up! Just hope someone makes the save!

Finally got around to installing the pioneer tool rack onto my M101a2 trailer tail gate.had to mount it up high to clear the frame when tailgate is open.

Very cool trailer, are you going to rescue it?

Thanks again for keeping me up to date on the alternator. The red primer is fine if you like red. Civy trucks didn't have any paint at all or just a very light coat of black paint from the factory. Personally I would just get a couple cans of spray paint OD Green or flat black and just give it a...

The red indicates primer. Your axles were replaced at some point and not painted! Let me know how your alternators work out for you. If they work out I will order two for myself. Thanks, Dwayne

Sorry to hear this! Have fun at Ft. Stevens!

It should up shift from first to second at about fifteen mph indicated and from second to third about twenty five mph indicated. Linkage has nothing to do with auto up shifting. It is a vaccuum issue. Start at the vaccuum pump. Disconnect the rubber hose and see if you are getting vaccuum. Then...

Thanks, I have been looking for a spare and I heard horror stories about getting the wrong one! I have been running Dexcool, the orange for two years now with no problem. You just need to make sure no green stuff is left in the system. Thanks again, Dwayne

Where did you get it and what part number water pump did you use?

Mine had the same problem, except after I tighten it up it still had the sound. Looked again and the front inside corner was rubbing the frame. Thanks to GL forklift the plate is bent and I was unable to bend it back in place. So I slit a two inch piece of fuel hose and slid it onto the shield...

What I did with mine was left the military lights and just added civy lights from orielly's.

nopics

Third weekend in July.

Looking good Scott! It is what your truck needs is more lights! LOL

I have the tilt steering column installed. The other parts I can get. Just didn't know where the wire the washer motor into the harness. Thanks!

No problem just here to help! The nuts holding on the spindle are one time use. I got mine at ace hardware. Do not use nylocks because of brake heat can melt the nylon. The rest is fairly simple. If you have a TM or a mid 1980's Chevy repair manual, it helps. I replaced all the bearings and the...

I bought a three inch piece on 7/8" hex stock at my local metal supply store used a socket a breaker bar and a piece of pipe about six feet long over the breaker bar to get the king pins to break loose. The socket for the wheel bearing nut I bought at napa. You need it to torque the bearings...

Any pictures of wiring changes needed for the washer pump in the fluid tank?