Search results

If it's replacement "Rated" brake line it is fine. What your most likely seeing is it's the newer nickel alloy lines That are much easier to bend and form. It also does last a little longer against corrosion than traditional steel lines. Tom

There is a adjustment screw on the throttle linkage, left side of the injection Pump. You should download the TMs if you haven't already and study them. Tom

Beautifully Done. Better than New. Well Done. Tom

John, Welcome!! Glad your recovering from such a tragic event. Link don't work for me 404 not found Tom

The stop linkage/lever is below the top cover. The main housings are different between the two. You can however put a cover off a solenoid type pump on a Mechanical pump and override the linkage to control it with current. One such pump that comes to mind is a Case 580 B or C that uses a...

A lot of earlier Industrial applications, tractors, equipment, used a mechanical shut off, Rather than solenoid. After early eighties most were solenoid controlled. Tom

Yes there is a plate that needs to come off,then remove the push rod. It will probably fall out. Install your block off plate with sealant. Tom

Lift Pump on lower right front corner of the engine block is leaking or frame to pump hose. Tom

Sea foam is Good stuff. Next time it acts up play with the choke out and in a little to see if makes any difference. If it don't then it's probably not fuel related. Tom

That's too pretty to install. Nice Job! Tom

Fuel tank skid plate Tom

You need proper tools, As far as Yoke removal you will need puller. Tom

The three relays on the plate under dash are 1 Starter 2 Volt meter 3 Gen 2 charging relay Tom

Google vintage truck glove box bumpers. Most of vintage cars and trucks used varying types on glove box doors. Tom

I don't have a part number, but this link might help identify it. https://www.clagrills.com/grillpartshelp/glossary/flare-fitting.htm It's 3/8 45deg. male flare nut. Tom

You need to determine if it is algae or bio diesel separation from old fuel. Of course if your not using bio blend or the fuel is relatively fresh, then it could be algae From water intrusion. I just went through the bio separation in old fuel.(six months) The shelf life of biodiesel is...

"I put a hose in the top and it runs out the bottom but does fill all the way back up to the top. The bottom flows well but might have some Plugged tubes." "Might have some plugged tubes"? That radiator needs to come off and sent to a shop. It's plugged up! Tom

My M35 will run at 160 all day long until you work it hard then it will reach 180,and then The T-stat opens and the temp comes right down again. With the manual engine fan and a oversized radiator these trucks run cool. I would try a simple flow test of the radiator by holding my hand over the...

None of those parts are for a m37 that I can tell. Does appear to be a winch PTO drive shaft, bit for what? Tom

See if this will help. Click the image, then click it again Tom