Search results

Put the felt side of outdoor velcro 3/4" in the window tracks - run all the way down so works both with windows up and down. Replace felt window seals - again run all the way down so works with windows up and down. Tighten up the window frames and pins the rollers run on if loose. Replace...

If you haven't already, see this thread https://www.steelsoldiers.com/showthread.php?156781-soft-top-red-dot-A-C-compressor-bracket

Mine is in same location. Was an existing hole there from the military for something.

Those inside mounts are pure red-dot, the condenser is a red-dot, but mounting is probably built on site - not original red-dot

I've finally got my Red Dot A/C installed and have a question about the amount of R134 needed. We've added 6 lbs of r134 and temp output is around 60. Started with the recommended 4 lbs, siteglass showed bubbles and foam and gauges showed system low on r134 so mechanic added a little at a...

I have a couple MileMarkers with that same extra valve, so watching to see what you find out.

No, wasn't the main culprit. If I turn off the disconnect routinely, the rear battery slowly works it way up in voltage. When it gets to 15.6 (with truck running) volt regulator shuts off alternator. I've found if I'll leave disconnect on at night on occasion so there's a little drain, battery...

In process of doing this. A diagram of plumbing and any other info you can provide would be most helpful. Thx

There is a gasket over the windshield and on top of the rear fenders. There are two windshield clamps, and 4 brackets. Then you need 3 strong friends or a tractor, forklift etc http://www.amtechcorp.com/spareparts.php

Here is install manual: http://www.hummerknowledgebase.com/driving/dwf.html

https://www.tirechain.com/37x12.50x16.5.htm Just bought 2 sets of the heavy duty cam style ones for the hmmwv. Haven't had a chance to test fit them yet.

Whole bracket pretty cheap on auction site - search for '5340-01-332-7515'

Once our's hits temp, it stays there. Fan kicks on and off, but just holds it around 210

I may be off here so check with the pros, but I would think if unplugging TDM engages fan, your Cadillac valve is probably good, I'd be more suspicious of the temp sensor or something between sensor and valve. TDM could also be bad and forcing fan to disengage all the time, but it's cheaper to...

Think you may be getting this backward. When the fan gets hydraulic pressure, it disengages. That way the fan defaults to on if pressure fails for some reason. So with everything off, the fan should be engaged and difficult to turn. If you unplug the TDM while running and fan engages, then...

Can we see pictures and have part numbers?

Silly question, but it is a 24v alternator isn't it? 14.5V sounds like output of a 12v unit

This might be a good addition to the TM's if someone can move it there

Kinda what I figured, I'll put it on calendar for next year

Is there enough going on Sunday (trail rides/ buy sell) to be worth running up from NW Arkansas or are most pulling out pretty early Sunday. Any HMMWV part sellers going to be there?