Search results

Its the U Joint on the transfer case end of the drive shaft. The yoke just pulls out of the xfer case.

Thanks for all the info. AutoZone gave me one for a 84 3/4 SUB and it did not fit. But these are the "fun" things about owning a MV.

I "think" that was for the rear U joint... He said the NAPA had the front one, but did not reference a part number.

m1009

Rear driveshaft M1009 U-Joint on the yoke. Anyone have a civilian part number for it? Thanks...

Ahh, I was wondering if it ran to the firewall.. thx...

I do not plan on installed a .mil radio. I would like to install a few 12v item on the rack. I have looked in the TM's for info on the power cable and how it is wired into the truck. I would like to rewire it for 12vdc only. Can someone point me in the right direction on doing this?

Auto Zone had the relays out near the "urban" lighting area. They were $4.99 each. As for the starter relay, dont fool with it. I took mine out and put a 60A starter switch ($10 @ auto zone) in. I drilled a hole with a step drill next to the voltmeter. Turn key to on position, press button.

Good Lord Man!

The problem is there are no holes on the back side of the axle to loosen the brakes up. After a night of letting PB do its work, they both come off with a few firm whacks of a hammer. Now I'm about 1/3 of the way into the job. Going back out to pull the c clamp that holds the axle. Fun...

You would SWEAR these things have never been off in 25 years! It finally got too late to keep pounding on them so I will start again in the morning. I put some PB Blaster on the lugs and hub area to soak. I have to remove them to facilitate a rear wheel bearing replacement. I started to get a...

WTF is that on the hood?

Yes I do plan on joining. It might have to wait a month or so until I officially do the paperwork.

...YOU! The taxpayers of this great nation!! I would like to thank all of you for my, literally, BRAND NEW TRAILER! Straight from the 101st Airborne. The stickers on the reflectors have not even been taken off... Excellent shape!! 2 NEW Tires, nubbies still on them... It towed like a...

One of the two alternators were bad, replaced it. Installed starter button. Replaced section of leaking fuel line. http://www.youtube.com/watch?v=UlUEUgbzmek http://www.youtube.com/watch?v=KZBtmIWCMB8 Put a 100amp alternator from a 1975 Caddy on the drivers side. Saved the core to be...

Check for voltage at pink lead on fuel injector pump fuel shutoff solenoid while assistant cranks engine. There should be at least 9 volts. If voltage is not correct, trace circuit. (See wiring diagram E-3 or E-5) If voltage is correct, perform step 2. Disconnect pink lead from fuel injector...

I cant get the charging system to work properly. Last night I found someone removed the bosch relays under the dash, so I replaced them. I saw the diagram with them listed, I was just wondering about the physical location under the hood. I have a M1009.

Great folks at Camp Beauregard in Pineville, Louisiana, no hassles at the gate... Good directions to where I needed to go... It took about 45min to get everything ready and to load. Here it is ready to roll... My iphone was taking some weird pics... They had to jump the truck from a Humvee...

Looks like it had no rear window also. Would be covered with canvas with a plastic window. Troop seats in it also. Pretty slick looking setup if you ask me... If you have never watch it, and you are into TEOTW type stuff, its pretty good.

It had a very unusual rack/roll bar setup on it. It also had a open roof that was covered with canvas. I know this was filmed in Canada. Is this a mod Canadians made to their 1008's or is it for TV?