Search results

Jtonka filter set up is the only way to fly:-D

Just got the # 34787 front.

Im looking to replace the front shocks on my Truck and the drivers seat, I need the part numbers for the monroe replacements. Any help please.:wink: K.

Yes sir spin on filters are the way to go and Jtonka is the man with the plan:-D Easy in easy out;-)

Check and tighten all bolts, Grease all Zerk's and U joints. Theres some in the drive shafts too. Repair leak in rear axle Easy fix. Check oil in trans, transfer case, diffs flush and change if nasty. Check front axle for leaks in inner seal and grease front king pins. Clean pressure valves in...

Welcome to the green disease:-D Ebay is also a good place to look. Hubby bought both of my toys there and parts are plentiful. K

Is not the A3 rim a 2 piece with a larger O Ring that comes apart when you remove all the bolts around the rim? What happens when you try to install the tire? won't the tire bar cut the tube when it went around the rim if the lock ring was welded to the rim?. I say go for it and post Pictures...

Hey Carl, Later invest in a set of spin on adapters, Makes filter changes quicker and cleaner. Jtonka makes them. :-D K. P.s. run tank pump when draining filters;-)

:-DCool I used the Bullet 3 1/2 race muffler:-D

One that runs, stops too:?:;-);-)

Also check the ground cable. A faulty ground will cause a no workie starter too:-D

Oh My Bad RTV silicon. Harbor freight has both pullers. I used the 3 1/2 socket to start it in then a flat end punch around the edge until it was seated.

Call around to local Mobil mechanics, Down load the TMs and give them to him. If its just wheel cylinder its a easy fix. Make sure when you get it home to check all the wheels for leaks. Front axle seal about 2 hours. Rear about 40 min rear easy. Make sure the key way is RTV good if not it will...

Big tub to catch the oil and lots of paper towels.:-D

You need a large rear wheel bearing puller and slide hammer, install it behind the seal housing and pull hard. The silver retainer will pop out. make sure to silicon the new seal and the housing around the seal retainer ring and make sure the flat side side of the seal is facing outward. Drive...

Speedo cable maybe bad?

See John isn't dead.:wink:

About 45 at start up 20 hot idle.

OD iron has a 12 way plug kit and mag 24 volt lights

Change the cap for a new one, Keep the tank full, Use water remover additive, Get good fuel from a place that sells a lot of it, AKA truck stops:-D They have a quick turn over in there tanks and less likey to have water in them.