Search results

Run through a Bussman Equalizer input it takes care of the balancing.

I find it hard to believe those are the same grade of build. But each his own.

I had 2 Chinese pulse chargers fail. When parked outside the 60A 24v solar panel keeps it topped up. I might have to tear the last pulse unit apart to see what's up. The 1st one went up in smoke lol

A commercial grade 24v 200A alternator isn't exactly cheap. I have a cheaper source than these, and love it with the Bussman Equalizer on my rig.

I love donated...

Keep in mind that some of these builds you see contain a lot of "donated" components in exchange for the marketing plug on their YouTube channels.... The average guy, for example me, doesn't buy Scheel- mann seats at $3-4k a set, we buy Pacifica take-outs for $200.... Have an open mind to what...

I've been using SolidWorks for decades and with my upcoming retirement a choice of software is in the works. Could you contact me about your experiences with Onshape vs Fusion?? Ohiobenz@gmail.com Thanks.

I build both a replica and custom shark type one. PM me for details.

I had problems with my manifold, and documented the teardown of a valve. Its in the Facebook Military Vehicle Camper Mods page in the Brewser album. That screen is stainless, so you can't retrieve it with a magnet. I used a small pick to first rotate, then pull it out. Cleaning resolved my...

A couple clearance holes for bolt access/removal. Not tied to the trans mount.

He works for Acela now.

Strength. That notch, even tho boxed is a significant reduction in strength under flex.

If the pic of the notched beam is the final location with regards to the transmission mount, I would recommend a plate to restore strength to that area, just in case.

Filled up the new aux tank with 55 gal of diesel :cool:

No crickets here my friend lol... Here's why they're not in there yet - lack of an indoor facility, that allows me to take my time doing the job. But that's been addressed now. If you do a little research on the mods I've done so far you might realize I'm not exactly afraid of tackling this...

I paid $4k for new ones.... yup... Should have bought the gears and rebuilt myself, but time sometimes gets away from me. $3500 to install? Not happening!!

From everything I've seen posted so far, it would appear that wear in the spline ends up being the destructive vibration. Does that wear result from being out of balance? Improper phasing? Lack of/insufficient/incorrect grease? Worn U-joints? Soft spline joint materials? I think if this was a...

"Getting wallet raped by a community member" Check...

https://www.ebay.com/itm/3-Quart-Double-Acting-Hydraulic-Pump-Dump-Trailer-Power-Unit-12V-Control-Kit-/184105492976