Search results

Color ID good idea. I could see myself also forgetting which are in.

$200 gets it flow tested and timing advanced at most pump shops. Maybe an injector is stuck open if it is knocking. Closed would just be misfire (?).

Anything can happen. Could very well be an injector as mentioned. There have only been a couple of pump failures here, but they typically result in a no start. You can have a shop verify the pump flow across all 6 cylinders for like $200, includes setting the injection timing to any new spec...

Knock knock....... Were you the one with the cracked block? I forgot and keep asking this...

...as long as the #2 rockers don’t fall off while doing so. :driver::driver:

I planned to drill on the lathe then tap with the mill. Would love to tap on the lathe as well,but no way to have the tap feed in at its own rate on the lathe because the tailstock just has a crank wheel on its end to extend it vs the mill has a pull down spindle depth lever which can let the...

If the flange sits flush with the rear face of the gear housing, can you just rotate the flange so it turns the screw loose? I have done this a zillion times on things. Should be able to if the plastic pin is not there at all anymore?

Pin not required, but handy. You can also find #1 TDC using a self made pointer against the harmonic damper and rocking to each side of TDC with #1 valves cranked down excessively (factory approved method). If you plan to advance the injection timing at all, you would need this method and not...

Welcome and congrats. Real trucks have air horns (looking at your sig line). Not sure your mechanic is correct, air horn should also suffice?

Just buy and install a replacement. It is only used when synchronizing injection pump timing. Otherwise, it stays retracted for the most part. Your engine may have been cranked or started when it was left pushed in, and sheared it off. Why are all these things falling off your engine...

You’ll get a box of broken taps, and compliments on your welds.

I may see if I can buy one of these "floating" tap holding chucks tomorrow when I pick up the tap, if they are not crazy priced. Looks like it is spring loaded (or not) in the tap pressure apply direction, to lessen the direct influence of the spindle handle position. The self-reversing one...

As long as he read the manual that came with it, he should be all set.

Thanks. Definently open to any and all opinions/advice on this one. YouTube had all sorts off fancy self-reversing heads and drill press depth switches. I don’t have any of that, so I’m just going to run it straight up and see what happens.

11 new torque rod end links just showed up at my desk today. So, tomorrow I am going to pick up a spiral flute tap (?) for the 1/2"-13 threads I am going to cut into the back side center of them for the 6" diameter retention plates. I really don't feel like hand tapping twelve 1/2" holes, just...

It does look good. I don’t even know how to turn an arc welder on.

Oh geez, here comes the welding police in 3..2..1.. “You should not use flux cored post-flow wrong gas mix chrome-moly reverse polarity work hardened spool gun in your weak penetration of underwater basket weaving project!”. Watch... These welding threads always turn into a pen!s contest...

Your stuff is broke also? This is supposed to be a power thread. Do we need to start a carnage thread? I could go first with some jumped dog bones, maybe a wire harness that had some spontaneous combustion going on...

Should not be any froth. This means air. A good bleed should only be pure liquid only. Keep working backward until you have fluid only when bled.