Search results

Welcome from Centre County!

This what I used on my M1008.

My M1008 has a plastic/aluminum one from Auto Zone. It has more than 6,000 miles on it under some extreme working conditions, so far it has been good.

It is It is similar to this one. The mounting bracket goes between two of the trailer bed horizontal members. I believe its a modified piece of channel.

Not easy to see, but we added a bar between to horizontal members to hold the spare tire winch winder.

That is where we put the water tank, behind the axle. I will get pictures tomorrow of the underside of the trailer.

I will see if I can get a few pictures tomorrow or Saturday when I pull it inside.

It does fit in front of a M101A2. We put a crank up spare tire winch in mine.

Relay Issue and Repair

Yes it is.

Picked up the M1008 from Hillbilly Wizard yesterday. The changed out a multitude of drive line parts that needed replacing. Also changed the front and rear differentials to 4:11. The truck runs much better at highway speeds now. John and his crew are great to work with, they took care of...

Did you go to Pops on Rt66??

Picked up a decent lower front seat from CUCVRUS. Removed the upper part and after some re-threading of the lower attachment hardware, I was able to get it all back together. Sure wish I had this completed before the Convoy. The newer seat is much firmer that the old worn out one and fells much...

There is just talk about going back to Alaska but no firm plans or official word on this happening.

https://www.mvpa.org/convoys 100th Anniversary of the first Transcontinental Convoy the US Army completed in 1919. We started in York, PA and ended at the Western terminus of the Lincoln Highway In San Francisco, CA

After more than 5000 miles on the MVPA TMC19 Lincoln Highway Convoy, changed oil, oil filter, fuel filter, rotated tires, greased all zerk fittings and replaced the rubber flex line at the transmission. Truck ran great and I only had one issue with a weeping #7 injector return line. Cut 3/8" off...

Done.

Please post an ad in the Parts Wanted section. It's free and may get better results in finding what you are looking for. Thanks.

I would get the 5/16" cord. 7/16" may be too large and not be able to fit two runs thru the eyelet. https://www.mcmaster.com/epdm-rubber-cords

More new paint for Leonard, the S250 and the M101A2.