Search results

Plugs are on the way, make sure to update us with photos of your build

Did you get your jenny fixed?

https://www.steelsoldiers.com/attachment.php?attachmentid=602120&d=1452034471 Do you know military Technical Manuals (TM's)? The above link is for the ARMY TM 9-2815-254-24, for IP pump removal, start on pg 57 on pdf reader, or TM page 3-31, task is 3.11.1. IP pump installation starts on pdf...

https://www.steelsoldiers.com/showthread.php?148936-All-the-TM-s-you-need-to-work-on-the-MEP-804A

Yes, J5 is trickle charger, J8 is the block heater. Also, I edited my post #16 to include the genny

I might also have a plug to fit the J5 .

I have one left. It only has short tails on the end so you would need to add more cable to go to the building.

This is what i came up with so far. https://www.steelsoldiers.com/attachment.php?attachmentid=674267&d=1491493802 The above link is for the hvac, the below link is for the genny https://www.steelsoldiers.com/attachment.php?attachmentid=674268&d=1491493840 the next info was stolen from the...

I may have a connector that will fit that J1. What is the dimensions inside the collar? Does it give you an amp rating for it? 60amp? 100 amp?

Try running with the fuel tank cap removed, if it runs with no issues, clean the tank vent. Also look in the pleating on the fuel filter, might have hoses breaking down.

well

ok, epoxy had time to set up, what did it do after you got it all back together?

His first post said hi from Washington

Best equipment in the world build by the lowest bidder

Kat 33118 (orange can) believe that is NAPA KBi Diesel Start, (yellow can) 20021

You did not do anything to provoke this, sometimes things fail. other advice, ground it, especially since its new to you. Adjust the magnetic pickup unit. New oil, oil filters, fuel, fuel filters, test the coolant, good batteries. These units dont like low voltage. You may need to get new...

If you need a new one after inspection, e pay has one listed

Fuel is not supposed to come from the wires. Remove the actuator and inspect it, here is the 'manual' for the actuator https://www.steelsoldiers.com/attachment.php?attachmentid=705577&d=1509045543

Is there any updates to this thread? Kinda curious how you coffee biz is going, cause we all love coffee.

https://www.steelsoldiers.com/showthread.php?173099-Manuals-for-the-MEP-806B there are all the manuals you need for your set, minus the -14. test the actuator first, the troubleshooting for it is #7. unless you already did test it to find it was faulty, I have only found 2 actuator that...