Search results

HMMWVs are just fine loaded to GVWR, so don't feel bad about doing it. Just stick with the stock springs and suspension components. (The alignment is usually set on the HMMWV at GVWR...)

this is the routing I ended up with, but I’m not sure it’s correct. (My HMMWV was complete missing the duct, so I didn’t have anything to go off of)

I just replaced the missing heater ducting on the drivers side, but I want to make sure I have everything routed properly. Does anyone have any pictures of where the duct drops down (aiming toward the floor), and how it's attached (or is it more less just lose)? The 24P-2 Figure 331 shows a...

My advice, check all the glow plugs, change all the fluids, looked around (especially under the hood in the lighting compartments and above the steering shaft in the dash) for chaffed wiring that needs to be fixed, check the portal axle nuts, make sure you have good tires and wheels on it. If...

I only have one position on my HMMWV. Based on how yours is, would be upper.

My drivers side mirror. note I don’t have them straight out, instead turned to the side. This works for me.

Can you post a picture looking down the side? I’m wondering how the edge of the tire and body side compare

MacMotors is another selling of reputable parts. Note, they're not the least expensive place, but they often have things others don't. (Same can be said about SECO, Eastern, and Kascar..). It pays to shop around for things, and all of the sellers listed in this thread do a good job listing if...

I was going to suggest trail worthy since wig splitter is out of stock. (When I bought them, trail worthy was out of stock!) Good luck be sure to post a review here.

not right as far as I know. I’m using PVC inserts from wig splitter. Shaved off some weight, but I still have the bead lock.

And the rest of the dash is reassembled, the HMMWV is running all the lights, gauges, wiper motor/pump, etc work

Well wiring is now repaired. All of the stuff in the left of the dash is reconnected. Need to finish installing the instruments and the high beam switch. Then hopefully it works. (So much for todays plan to go to the lumberyard for remodeling supplies)

First picture was the washer sprayed circuit you can see where the wire melted… second bundle is a bunch of dash grounds. They are both chaffed and I found them connected with a red wire nut.

Found more wires that were chaffed, looks like the rest are all grounds.. but I’ve got about 8 wires it “fix”.. at least

You’ve got to see this to believe it. circuit 71C, windshield wiper circuit. Apparently was rubbing on the steering shaft, shorted, welded itself to the steering shaft knuckle, and then (luckily) broke. Argh, now I have to find both ends and get this fixed, but could have been worse!

First you need to add the reverse switch and get power to it. Lot of the time people will buy a kit (with bracket and switch for the 4L80 or just hte switch for the 3-speed). You split power up at the horn, run it back to the switch, then back to the lights (I went along the main wire harness...

lol the roof, sides, walls, etc leak on HMMWVs.. everyone who ever drove them in the service tells me they all leak. Even after replacing seals and other fixes, everything still gets quite wet inside during rain. The main thing is to avoid water on the dash (just for comfort of the driver, as...

In Minnesota the price is recorded in the public record as part of the title transfer, so I'm sure they verified what I told them. But ya, that seems to be the way they are handling most of the initial pricing is based on what someone paid for the vehicle.

If you have authentic ones (or good copies). Just take the front housing off, turn the little metal clips inside and remove the clear lense. Then you can paint it without worrying about taping things off. (That is how I did my trailer recently.)