Search results

there is absolutely no reason to put grease in the knuckle. this is only for the really really old trucks that had cv joints in the axle. do you realize how much thrust is on the axle? somewhere between none and none. the thrust area and the spindle bushings get greased during periodic...

wix # 15070, napa 5221 or 5406

and without some elaborate relay system you will only have low or high not both. just use 24 volt bulbs, they are cheap.

take the shut off cover off and move the shut off lever to free it

i think you all are missing something here.......... these oil powered centrifuges are used on most large trucks as oil filtering devices. go to your local scrap / junk yard and look for a used unit. it will be much larger than the small things sold on ebay and elsewhere, and very cheap. for an...

5 micron is nowhere near fine enough. the ip head has probably 1 micron or less fit. i would not want anything less than 0.1 micron filtered fuel.

yep pretty simple, just be sure the pointer aligns with the marked tooth (under the shutoff cover) before you try to lift the ip head up. this is the only position it will come out in.

swap the springs side to side and see what happens

screw in

no cork gaskets on transmission, only paper

and don't forget that 14.5r20's are the same size as 11:00-20's with respect to bed clearance so maybe they are the largest practical tire size.

bent frame would not cause noise unless it was REALLY obvious. most likely a bent axle housing and that would also be obious just be looking at it.

this is a very simple thing to fix. turn the switch to service brake and see if you have power on one of the wires to the brake light switch. if yes the problem is in the rear of the truck. if no do the turn signals work? if yes replace the turn switch. if no check wiring from turn switch to...

and subaru is comming out with a diesel car????? bad timing unless it gets 100 mpg

a search of ebay showed new switches from $20 to $35, including shipping.

they would be bullet proof only to a very small bullet...........

that plug does not use any seal and must be torqued to specs (given on the label on side of ip head) sounds like you need a new ip head. consider having yours rebuilt. don't pull the whole pump, just the head.

new on ebay and cheap. that is a circuit breaker, klik-on brand i think. just throw it away and buy new, they are cheap.

xm757 fuel tanks can't be that hard to find can they? i know where at least one is i think. frank masoner in tulsa area. good deuce tanks should also be easy to find. $100 should buy a real clean one.

also you need to download the manual and read it in bed. this will greatly annoy the wife, always a good thing.