Search results

Please consider posting a picture in front of all this while wearing cut off jeans, an old thread bare Lynard Skynyrd T-shirt cut down into a "wife-beat-r", with a banjo in yer hands. Pretty please. Maybe 22 inch spinning rims on the HMMWV too. LOL (Just joshing)

In all honesty, I think if you do not secure the front of this properly to your vehicle, it will blow off and potentially hurt someone when you are driving at the speed. Good luck.

saw this post with this video and can’t stop laughing. Thanks.

Do these vehicles have anything that functions close to a choke. Is it possible something is functioning like a choke that is cold? Thinking along the lines of a gasoline engine, so sorry if I’m wrong.

With all due respect.. Jet fuel is essentially Diesel, no? On old Diesel engines "spec" is relative. Things get worn and loose. I don't know so I'm not sure about oil as it might contain impurities or not burn properly. I don't know so I'm not sure about adding gasoline/petrol for an emissions...

New wiper fluid motor. New wiper spray nozzles. Cleaned windshields and then hit them with "Rain-X" so now water beads and falls away nicely. Installed new rear chains for hatch as mine had bad plastic insulators that were allowing damage to paint and lights. Just began installation of tach...

First thing is get injection cleaning fuel additive and clean system. Run a tank of this stuff, then use entirely new tank of only Diesel fuel without additives for the test. Run only fresh fuel for the test! Second I would only let them test the vehicle after it warms up. Vehicle should be...

run biodiesel and only test vehicle when fully warmed up. back off on timing diminish fuel flow at injection pump control.

Place an auction on flea pay with a paid link here on the classifieds and a link on craigslisp. Place lots of pictures. A lower reserve price will make auction more enticing. Good luck

Bulldogger makes a beautiful looking soft slatback kit. You should look it up. you would also have the ability to place a clear plastic rear window. Most helpful when parking.

From what I have seen, just the bare hard top and sponsons without hardware or C pillars or turret, etc go for 6 K on flea bay.

So where would I hook this alternator up on my 6.2 with 60 Amp alternator??? I have a Dixson 00049383 I can figure out the 24V Pos and Neg. Where do I get the + and - tach signals? [EDIT] - It would appear I need a tach mechanical sender. Does a 6.2 have one normally or can I install one or...

Sometimes you need stuff ASAP. I like site sponsors and prefer to use them, but sometimes waiting for a PM when you want to get something done is painful.

Just call Kaskar. That’s all I did. Everything fit great.

mine can’t even figure out how to open the X-doors. I’d trade with you in a heartbeat. LOL

Usually matched set means same lot number, same run, same turning, and spaced next to each other on the spool. For now the screaming angry cat under my hood has been silenced, but for safety and reliablility I just want new belts and hoses and such. Thanks Juan

Ordered a few y connectors and male and female packaged connectors. When they arrive I will steal power from the horn, as suggested. I want the rear camera always on. Gonna mount hidden behind a predrilled hole in the rear body. The camera will steal power from the rear light once I swap to LED...

So I used to use my Durango and LandCruiser for stuff like this. Two inch pink plastic housing insulation cut to fit the floor/bed. The kind of stuff you get at Home despot in long planks. NOT the fiberglass roll stuff or you will get itchy and harm your lungs. On top of that I placed futon...

So, I need power for my 24V back-up camera, and I want it to turn on when vehicle is running and turn off when I stop the engine. Which wire is live during the drive? Is it safe to run a "Y" connector through that wire to a relay that will turn on and off when I kill the engine? My desire is...

If I were you I would take good clear photos and print them out yourself using an inkjet printer on a plastic type medium.