Helmet top install

[TexF18]

How hard is it to install a helmet top on a ragtop m1123. Does it just bolt right on or do you have to switch out windshield frames etc

 

[Coug]

How hard is it to install a helmet top on a ragtop m1123. Does it just bolt right on or do you have to switch out windshield frames etc

will bolt right on.

I don't think you have to remove the channel for the soft top at the front of the frame, but it's been a few years so don't remember exactly.

 

[Guyfang]

There is a TB to explain this job, I believe.

 

[badgerd]

You’ll need to remove the soft top channel from the windshield and the C pillar.

Installation instructions, for the Amtech tops, is the whole way at the bottom of the page here:

Legacy 4 Door - McClarin Composites

Helmet Hardtop® : Standard Convert your canvas top to a one-time permanent solution. Our Standard Top is our most popular model in the Helmet Hardtops® series with thousands in use by the Armed Forces today. In this configuration, the cargo area is covered, similar to a sport utility truck. We...

www.mcclarincomposites.com

Sent from my iPhone using Tapatalk

 

[TexF18]

You’ll need to remove the soft top channel from the windshield and the C pillar.

Installation instructions, for the Amtech tops, is the whole way at the bottom of the page here:

Legacy 4 Door - McClarin Composites

Helmet Hardtop® : Standard Convert your canvas top to a one-time permanent solution. Our Standard Top is our most popular model in the Helmet Hardtops® series with thousands in use by the Armed Forces today. In this configuration, the cargo area is covered, similar to a sport utility truck. We...

www.mcclarincomposites.com

Sent from my iPhone using Tapatalk

Thank you

 

[Dieselmeister]

Thank you

I just installed one. It's relatively easy. Just make sure everything is aligned before you drill any mounting holes.

(More manuals are available on their website).

 

[Mogman]

Make sure the rear side and rear "lips" are tight against the rear of the body, you may have to put a ratchet strap across the back to pull the bottom of the helmet top together so it fits tight against the body before drilling the holes for the rear mounts.

 

[Guyfang]

I just installed one. It's relatively easy. Just make sure everything is aligned before you drill any mounting holes.

(More manuals are available on their website).

Please upload this Instruction book in the TM upload thread. I will then put it in the correct forum. Its good you posted it here, but in a year, no one will be looking here, but in the correct forum they will find it.

 

[Mullaney]

Please upload this Instruction book in the TM upload thread. I will then put it in the correct forum. Its good you posted it here, but in a year, no one will be looking here, but in the correct forum they will find it.

.
I pushed 3 books and 2 Latch books.

Temporarily located at:

Helmet Top installation instructions for HMMWV

. The original discovery for these instruction books was made by @Dieselmeister on the AmTech site. Latch instructions from Fairchild Fasteners also attached.

www.steelsoldiers.com

 

[Guyfang]

All taken care of.