Search results

Yes, just no weatherstripping around the doors.

I'm hoping that if it is soft enough, and compresses well, it'll at least close the air gaps.

I am not trying to stay dry.... just a little quieter.

I had to cut off the old beat-up weatherstripping on my hard doors and am looking for alternatives. The OEM seal wasn't thick enough to form a good seal around all the corners. Has anyone found a good aftermarket alternative? Seems like a 1" wide, thick seal with heavy-duty doublestick tape...

There is a thread out there explaining the two heavy-duty bumper options in detail, but this is all I could find for now.

Just a tip here - I've used this self etching primer rattle cans on some small parts that I've had to take down to bare metal and it works great. Plus, it turns out to be a pretty nice olive drab color... https://amzn.com/B003CT498A (But it's only 5 bucks at Home Depot) Rust-Oleum 249322...

For me it's been through relationships made here on these boards and in the community.

Sounds like you did it the right way.

Yep, had to modify the MSG running boards in the spirit of field expediency. Who knows how long it would've taken to find the correct Jack rails, etc. They have all probably scrapped with the SF trucks that had em. So I decided to cut off the original brackets and make these running boards...

Got the weapons mounts and kit installed for the parade. Fun weekend! The boys ready to roll, equipped with water grenades and super soakers! After pulling the cannon through, the ROTC guys needed a ride. It was a full combat load of 20 people!

No sir, a friend had it from scrap. Part of a bundle deal, so I don't remember how much. I'm just going to use it for rucksacks and hopefully ammo cans if I can fab them up.

Stumbled across the rear enclosure side walls as seen here: http://www.milsysgroup.com/product/humvee-accessories/GMV63000. They're for an 1100-series truck, so not true to original form, but hey it gets the job done.

Fresh coat of CARC 9 on the GMV this week and got her show ready...

Been wondering about an air horn. Anyone done it?

Nice QRF truck by the way!

The rubber isolator mounts are shorter on the LED Headlights, so they are not a direct, drop-in replacement. You can remove the bezel on the old lights and unscrew the old isolator mounts & install them in the new LEDs. Or order six new ones, which I believe are 1/4".

I think this one might fit the bill. Any around that might be available?

PM sent

Installed a push bumper today... And pioneer kit. Ready for CARC prep...