Search results

As far as the DIY type I used it to coat the inside and bottom of my battery box. So far its holding up but it hasn't been that long. Also rolled it on top of the M109, hope it lasts :roll:.

Here's a few pictures....I hope.

I had to replace the generator regulator since someone removed it.:twisted:

Yes, went ahead and got the expensive one and now all's well.

:-D Had an electrician help with the final hook up yesterday and its working great!!!! Had the central air, 4 refrigerators, multiple lights and by accident the dish washer all running off the geny. The meter showed it was running at 55% capacity. Speddmon your posts helped immensley with...

Can't wait to see her with a little mud caked here and there.:grin:

:ditto:I've got State Farm on all my collector vehicles.

You might want want to contact a family member or friend who served and use their unit info. I'm sure they would appreciate it. That's my plan at least.

My M109 has it.

Thanks.

Vinny, great looking setup. Boxes are just like mine. Any obstructions in the wall when you fed in the new cable?

Thanks for the foldout info. What has me confused is that the switch box says 240 volt and there are 2 fuses rather than one. The foldout just shows one fuse. The rest of the diagrahm matches as I have 4 circuit breakers and 2 outlet strips with 3 prong receptacles.

Thanks, Ferro.

Not to pile on but... MIG welding is fine. As with any welding process including stick if its not done properly you are prone to failure. Plus you are correct that if your using seies 70 low hydrogen rods they better be coming out of an oven. If any of you have ridden any of the steel mega...

Does anyone know if the 115 volt disconnect box inside the van is wired to the external plug with both pins hot and the shell grounded or set up for one pin hot and one pin common? Can't find a diagrahm and haven't traced the circuits yet. Site searches don't seem to address this question. :|

Not trying to be a smart a$$ but are you for sure turning the correct shaft? :wink:

Hello, just wanted to know if you have any info about my M109A3? Here's the numbers: Registration 04A33171 NSN 23200771636 VIN 053210649 1971 General Products Jeep Div. LD- 465 White Multifuel Miles 19700 Bumper No. on driver's side A53 Picked it up from Ft. Reily. ** Just uncovered Bumper...

Thanks :-P

Sent westfolk a PM. Guys, give me a shot at the 2nd one after all I started the thread. :roll:

Mine has the 2 pin type.