Search results

The biggest problem is finding the M35 aisle at Lowes. Once you do that it is a piece of cake.

They show up on Ebay from time to time.

Then I apologize for the comment. I did find that it did not apply to non-commercial trucks or drivers. You are lucky your are in a county without the inspection. I was in Sumner and they had the inspections and a lot of people would take the temp tags and doctor them to give them more time when...

We shall see how it all shakes out.

The older ones could be flipped either way. I am pretty sure the newer ones can not be flipped and are permanently in a position with the headlight above the BO Drive.

RE: Re: RE: Re: RE: Vehicle Code legal...? Here is the section on the Federal Inspection. It allows for self inspection by Motor Carriers and the inspection only applied to commercial carriers. If he is not a commercial carrier then he does not need to comply and as I read it he could not...

RE: Re: RE: Re: RE: Vehicle Code legal...? And if a normal guy ordered them and just filled out the paperwork without complying with the provisions that seems OK? If that was the spirit of the law then we would be on the honor roll system. Any way you put it if you buy the stickers saying an...

It means don't bid against me on the truck. Just kidding.

It is a mechanical fan with a clutch. It will spin all the time but sometimes it is slipping instead of spinning the same rate as the waterpump is moving. It will always spin. They never stop. I don't think that has anything to do with your problem. Do you have a thermometer to physically check...

Did you check the coolant level? Were you getting heat from the heater?

One of my M1009s did not have the bracket below the seat. It is just a raised square about an inch wide with one side cut out so a flat headed carriage bolt can slip in. The same type of thing should be on the rear pass wheel well for the jack handle. I will see if I can get a pic for you.

Did Paul put in Urethane sway bar bushings? They make noise like that when they are dry. Crown Victoria do it all the time until the bushings are greased. Just a guess as I know Paul put in a lift kit. As for the cv joint, the M1009 does not have them. They have u-joints at the wheels and they...

Medlog, I could not find your stuff on ebay. How much for an AM-1780? I am not going to the show and would need it shipped. Thanks Chuck

Thats the right stuff. The jack and tire iron go under the passenger's seat while the jack rod goes on the wheel well on the rear passengers side behind the spare.

I think they are around 200 lbs and have to have the leg separated to be shipped.

At least I remembered part of out discussion.

If you have a Advance Auto near there I was able to get a loan a tool kit with several of the spindle nut sockets in it.

Kenny, PM sent on GP small. Chuck

RE: Funny. Here in Ann Arbor we have been called the Berkley of the East. The city council actually passed a resolution condemning military help to the Israelis. l think they also passed one condemning the war in Iraq. We regularly get some old hippies that have an anti war rally every Tuesday...

I am the kind of guy after one. If you spent over $2500 the last go around you could have gotten one from GL. Stay our of my way on the next go around. That is all I am going to say. No collusion here.