Search results

I own a set... It is not just pressed on Coug. After pressing in place it is retained with a very small screw requiring removal with an allen type screwdriver. EDIT - Sorry if the tone of my post is terse Coug. I'm tired and cranky... My son is choosing colleges. I'm choosing ways to go into debt.

Depends.... Did the A0 have those tabs? Me just wondering outloud.

There is a device you can connect to your air compressor for use to spread the half shaft boots and lift them up and over the CV joint. You just need to clean out the CV joints and grease them first. Best, T EDIT - https://www.steelsoldiers.com/threads/cv-boot-installation.194681/

Anyone got a picture of where this thing mounts?

This is an awesome little thread. I have one of these devices but I don't think I will install on my current rig. I have gotten used to the switch. I'm planning on getting a second HMMWV, and if it has a bad switch, now I know what to do. I wish Doghead remembered to remind the OP about the...

How did you make those planters? Please PM me.

Can't these be home made with 12 or 10 gauge sheet steel?

Well, I think POOO is self explanatory.

Just buy a regular grommet and drill a hole in the center. Make one out of a mold using black silicon. Use rubber that is half inch thick and cut a 3 mm large and then groove the periphery and cut a hole in the center. Use a 1/2 inch outer diameter tube and slit it down the center and place...

Our military for the most part did not need to park in Brooklyn streets. They were not confronted with the mentally and visually challenged drivers who park by feel after receiving drivers licenses in boxes of Cracker Jack. The pintle extension should be renamed "the pro-active rear vehicle...

You need to deal with one problem at a time... First is that mismatched 3 speed shifter on a 4 speed tranny. Then a custom mount for the shift for the transfer case. Might be worth going back to standard transfer case and shifter. You need to modify the current shift or purchase the correct...

Amaz0n.c0m

Heat and then straighten. Then re-heat and quench. Then keep at 700 degrees for a couple of hours and allow to cool slowly. Then polish. That is the industrial answer.

Please post

Welcome!... AND : nopics First of all, your shifter seems like a TH400 tranny, and not a 4L85E. Is it possible the shifter is set up in such a way as you're literally in 2'nd vs. being in limp mode?

Is it the belt OR is the tensioner beginning to fail?

Color me GREEN with envy. Really nice job.

I did some investigating. The inner plastic is there to prevent glass shards from being expelled from the window into your eyes in case of breakage. Knowing what I now know, I would get the plastic cleaned and polished at a marina that is experienced with plastic windows that fade with time.

Gamble, here's the rub... You asked about "power" [which means electric] doors. AFAIK, unless perhaps POTUS has a special one for himself, there are no "true" power X-doors. Power X-doors would not be EMP proof. Real X-Doors are sturdy enough, but they rattle, leak water like a sieve, and are...

Can you build me an M1083 just like the one you built? PLEEEEEEEASE