Search results

It's used by the STE/ICE test set to measure pump pressure.

My advice would be to contact db Engineering at 800nonoise.com or 1-800-666-6473 and speak to them about insulation since they're the people that make it. They did all the replacement panels in my M996A1 and they're perfect!

Tachometer Install:

If you use one of the standard military LED lamps like the one in your picture there's no additional resistor required. That's why I didn't add one to the drawing. The military does have splitters for certain applications but there's no place to put one in the glow plug harness so you'll just...

You can tie an LED indicator on the common line to indicate glow plug activity.

This is sounding more like a shifter adjustment issue.

You always want the engine off when shifting the transfer case to avoid grinding. With the engine off you can go under the truck and manually shift the Tcase into and out of range and lock and then restart the truck to verify the Tcase. If it moves that way you have a shifter problem. If it...

That hole can be used for many things as mentioned depending on which of the large grommets you use. There are large and small hole grommets for either battery cables or antenna coax and multiple hole grommets if you need to pass both sizes thru the panel. Since the trucks aren't meant to be...

If the dealer will supply it registered with plates it's a fair price in todays market. Not all that great, but OK based on what people are paying for them in the marketplace today. Make sure you can get it registered in your state before you buy it.

I like the power box but think I'd have swapped one of the cigarette lighter sockets for a dual USB charger port. Nice setup!

A little addendum here. Any time you install electrical/electronic devices in a vehicle you want to include either fuses or circuit breakers for protection and those fuses/breakers need to be rated to handle the current your devices are going to draw PLUS another 10-20% as a safety margin...

So will someone please post the numbers for the more desirable ones so we can put this to bed? Those 2 numbers I posted are directly out of the -24P manual.

Are CR seals #535094-60 and 534059 still the correct seals?

I originally posted this as a reply on another posting and I don't think it was getting the visibility it needed. I think this would be an excellant forum to get this information out to the group so that we could possibly develope a decent final design. Lord knows, Uncle hasn't been able to...

Speaking of schematics, has anyone ever come across real, full schematics for any of the boxes? The manuals are only vague about them and the diagrams are only representative of the signals in and out of them. There's been a lot of reverse engineering done on the different models but I don't...

CST, Keep in mind that to use the transmitter in your ASIP you should have an FCC license and legally that limits you to the 50-54 Mhz frequency, 6 meter amateur band. A license isn't hard to get now that there's no Morse Code requirement and a few evenings of reading one of the many available...

https://www.militarytrader.com/tag/rick-larsen-stencils I know when I did my M37 the type font was called "Condensed Gothic" I think it's slightly taller than standard Gothic type.

I'm an old man that's probably done half a dozen of these over the years and have always just lifted it up and rotated it over the frame by hand. There is no easy way that I know of, just bite the bullet and shove it in! :grd: Like Jack Kennedy said: "We chose to drive HMMWVs not because it...

Still after some LOW INTENSITY LEDs that will operate 10-30 volts and fit BA11s sockets. Everything I'm finding is too bright.

The repair ended up being a replacement front panel with a new keypad.