Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
mine with .69 od will do most if not all hills on I83 in PA pretty easily. fuel is turned up to max safe rate (1200°f pre turbo) i would estimate it is making at least 200 hp. max torque is around 1900 rpm so even when it does slow, it only slows that much.
first and easiest test, put a...
these engines are really sneaky about head gaskets. mine was leaking for 2 years before i could prove it. it would only blow coolant out during a long hill and never overheat. there is a chemical test that shows combustion in the cooling system, any repair shop should have it. the chemical turns...
for all the work involved, you might as well just put real power steering on it. all the parts are easily available and there are 2 boxes that fit really well. it has been covered here 100's of times
tom
a few basics that make the best truck: ldt465 with TD cast on the block. air shift transfer. overdrive trans. air ride seat. past that they are all the same.
tom
the kits i have on the classified are refined from an original NOS kit. they are paper patterns and give you all the hard to make areas, the floor and inside of doors are not included as they are easy to make without a pattern. what is included are the under side of the cowl, firewall, around...
if you are concerned about temp of oil, i will tell you that engine oil usually runs at least 100 °f hotter than the water temp. and with a turbo is will be even higher. trans temps on the 3053 usually never go above 160 °f. as for testing it, forget it, it takes much more than any of us have in...
seems 50wt is harder to find, that is part of the reason i used 40wt. it is also desirable to use non-detergent, but that gets even harder to find. any where from 30wt to 50wt is fine. shifting in cold weather does usually get a lot easier, and the trans operating temp drops 10-20 °f
tom
as in it has been impossible to find a trans with a good overdrive and also short enough to just replace the 3053. hence the od gear set that the bad weather in IL has delayed!
tom
that is still a painful od ratio. it has been impossible to find a trans short enough to fit and also have an od ratio that allows highway use. the 3053 can operate at much more than the design ratings if used properly and not abused. while it was designed for 300 ftlb, it has been used...
bad bearings also lead to metal in the oil which gets in all other areas and causes wear and failure.parts are fairly cheap so there is no point in not doing it right, new syncros are only $120 each for instance. bearings are readily available, but be sure you get the right kind, some have more...
with a pto, you probably have to remove it. the main shaft and countershaft will come out in the truck with stock gears. both the gears you need are easily availably here in the states and cheap. you should replace both, and find out what caused the failure. something foreign must have gotten...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!