Search results

Western Canadian Rockwell had the best price when I bought mine, but... see link below! If you do decide your going to order from them, I’d give them a call first and see if they will countersink the lug seats to the correct depth for you. Western Canadian Rockwell BAD This is what a...

I’ve got an erosion problem I’m getting ready to fix that could make them disappear.

Nah, they just mount them sideways.

Yep, just wanted to see the worst I could do. Now that I’ve got a gauge and my baseline, I might start tweaking on her knobs.

Hauled a couple 12ton loads of stone today, max boost was right at 25psi. Air temp was 80F, coolant temp 195, uphill, lugging 4th down to 1600rpm would spike EGT up to 1275-1300, just before transmission would downshift and bring EGT right back under control.

2019 Findlay Oh, Armed forces day show May 17-19 Interested in two or three of the mats. Roughly how thick are they? Also if you run across a couple more of the regular rectangular mirrors for the 939 im still interested.

Added a receiver hitch for winching junk up on the trailer, among other things. Not lined up with your trailer on the first shot?Use your crane, pick the tongue up and align it! I need to drop the hitch all the way to the bottom of the plate and it will match the rear hitch height perfectly.

Comparison to my dinky little 14.00r20

The Husky is rated from 19-26klbs on just two axles, so off road capacity on a deuce shouldn’t be an issue. Tires are 47.25” at the tread shoulders but they really bulge on the skinny little 10” wide wheels, to right at 49” in the center of the tread. I’d stretch your dog bones and go for it...

I finally got my gauges installed on my stock, the way I got it from Uncle Sam 8.3. I only had a chance for a short, empty test run up to about 50 mph. I’m seeing 24psi of boost, and about 1215F pre turbo EGT, kind of scary! Now I cant wait to load it up for a proper test, and see just how hot...

I had to beat my shutterstat upside down on a block of wood to get the piston out. If your seal is still in good shape, clean everything up good, your paintball gun oil should work, but as said go very light with it.

Sounds right. I found an ebay deal that I couldn’t pass up on a Horton 993655, 205F on, 198F off. I also found a cheap ALLENAIR 3CBX8B-Y Solenoid Valve 24V-DC 1/8IN NPT D622649. I still haven’t installed them yet tough to verify operation...

Think they where 13 or 14 wire gauge bits.

This is what I used. Be gentle, drill bits are brittle and shatter if you get carried away.

No cable, no biggie. Hate to have to track down the motor and possibly adapter though...

Yeh, motor set to one side shouldn’t have mattered, just as long as it, the transfer case, and axle pinions are all parallel with the frame rails. That way you only have to deal with your horizontal angles, which can be measured with a cheap Harbor Freight magnetic angle finder. Component height...

You’ve got to have a driveline issue with everything you’ve tore up/replaced since you first started changing motor mount locations. Is it possible your engine/trans was, or is not parallel with the frame, or at a really weird horizontal angle compared to your axle pinion? I think you’ve...

I’m going to guess it’s a bad ground, shared by the horn and flasher.

What can you tell us about the 5 ton winches? + price... And no I’m not asking about Extra Large Hookers!

Don’t think so, I believe m105 is six lug also.