Search results

Ive had good luck using a nut runner on my screw gun, and hold the canister body up and tight until the bolt seats, then just finish with a socket wrench. The twisting of the can body can sometimes distort the gasket.

Have you confirmed the petcock valve on the engine block (follow that drip line up to the front of the engine with your hand, below the water pump) is fully closed?

I know this is an older post (bumped for the Fernco info) but hoses are available in the classifieds readily. Or at least till the batch I ran runs out, doubtful I will run again.

I have OEM sets available complete too: https://www.steelsoldiers.com/threads/battery-hold-downs-for-mep-802a-or-mep-803a-88-20055-and-88-20060.208979/

https://www.ebay.com/itm/354363003656

You will want to check the sealing edge of the filter canister too.. if it has any burs, distortions, or tweaks of any kind... its never going to seal right again. Ask me how I know. Do you have the internal spring, and sealing washers in place on the bolt as well? They are available new on the...

No backpacking your 804 through Europe then 🤣

Great to hear, and thanks for following up.

The MEP-831A is not the most robust platform in the MEP series, so just a bad joke on my part I guess. I am sure those more well versed in this particular machine will swing by with their two cents... but you are on the right track. Fuel pump, all filters, fluids, etc. Relays, gauges, a way to...

An MEP-802A :ROFLMAO:

I don't know if you ever changed out the stock seperator or not, but if you haven't... your life will be easier with the roof panels off (as you need to remove the side panel near it, to get good access to use a chain wrench to remove the bastard). I would personally change out the larger...

Take the roof panel off above the engine. You see the hard fuel line that goes from the fuel fitler bowl, to the metering pumps near the pushrod tubes? At the left hand end of that, is the soft 'fuel return' line. You probably have a leak in this line, either at one of the Ts at the injectors...

If you find out that pump is functional, I'd part it out based on what you paid (starting with that pump!).

If Joe Biden can be voted into the highest office in the land, an Etch-A-Sketch website company can sell to the government. 2023, baby.

These folks are listed as one of the OEMs, along with Onan (so its probably whose actually making it). http://www.centroidproducts.com/ Their part number is C-A054F059

One available cheaper than anywhere else: https://www.ebay.com/itm/295471470827

I think this is a bad description... you might want to reach out to these folks: https://www.easternsurplus.net/PartDetails/10032/10-KW-Exhaust-Muffer-Generator-400HZ-MEP-813A Looks like the same Onan muffler for the 00X series, not an 813A.

There are a couple up: https://www.ebay.com/itm/294004090506

If your DC regulator tests bad, you can grab one here: https://www.eriksmilitarysurplus.com/vorebchforon.html or here: https://www.ebay.com/itm/223544362863

https://www.steelsoldiers.com/threads/mep-002a-and-mep-003a-dc-charging-system-test.94880/