Search results

sped, i did not mean you in particular, i meant the figurative 'you' as in anyone. it seems that by your own admission, that your trans was at least 1 qt over full when you had the problem. re expansion of gear oil, i don't know but i will find out how much it 'expands'!! most deuce trans at...

in the scheme of things, i would think a good bracket would be worth $100 tom

it wouldn't be the first time the army has been wrong................ i prefer to continue going by industry standards. tom

or it could be the low oil level!! trans should be filled to the fill hole. 5qts without pto. any less is not enough oil. if they wanted less the fill hole would be lower. anyone who has problems with the propper amount of oil has something wrong with trans and just doesn't want to fix it. i...

yeah, 35" diameter, maybe less!! i think you would have to start in 1st

so there is a snap ring on the front of the water pump shaft. should i assume the pulley is on the shaft with a key and will just pull right off?? has any one taken one off before? i'm going to make a custom pulley to drive an a/c compressor..... tom

these ratios would suck. 60 mph would only be 2000 rpm = no power, no off road capabilities. these are meant for the hill climing crowd with 600 hp

a few years ago i sold hundreds on ebay, never got more than $140 for just the heater

i think most people who set the idle to other than what it may have been, set it to about 850 or enough that the headlights don't vibrate a lot.

use the idle speed adjustment screw, see manual. any small amount of dirt or operating with out fuel primed, the stress on things when you had the fuel control misaligned may have been enough to hurt a already worn plunger. run it and if it gets worse get a new head, not repairable. new heads...

this usually means a worn out ip head. set idle up some and if it gets worse replace head.

also remember if no oil flow to comp there may not be much metal in bad places yet. but when you get that working, there will be.

3 SPEED 13,700 BTU 359CFM 403mm x 325mm x 154mm no heat

ok, i just ordered a new eveporator unit that will fit inside the cab up on the ceiling for $155, a new compressor for $135, and a new condenser for $107. i will take pics and make templates of the brackets especially for the compressor. using 12 volt equipment on 24 volts is easy on a/c, you...

jake is absolutely right..................now my 2¢ if you use silicone sealant for anything, you don't have the right to call yourself a mechanic. it causes far more problems that it ever solved. there are gasket makers that are quite good, and i used one ($40 a tube) for the oil pan on my...

so if it is russian, it is not a tiger.............. i'm so confused

of course you can paint the monroe green....................

this is a high pressure pump, as common as they are i would say just get another one.

monroe # 34787 is such a perfect fit they might as well be made for it.

to anyone who has one, the last i knew sam winer mtrs had 2 NEW soft tops, still in new condition. i paid $200 for mine, a VERY hard to find part...